How to Clean a Hair Dryer Filter and Styling Tools
Step-by-step cleaning for a hair dryer filter, flat iron plates, hot air brushes and hairbrushes, plus when to unplug, let parts dry and stop using a tool.

Unplug and cool the tool, then remove the dryer filter cap, brush or rinse out lint as the manual allows, and let it dry fully before refitting. Wipe flat iron plates cool with a damp cloth, and pull hair out of brushes and air brush heads.
Written for: People whose dryer smells hot, runs loud or shuts off, and anyone keeping styling tools clean
A hair dryer pulls air in through a filter at the back or bottom. Lint, hair and product dust build up there. A blocked filter means less air through the dryer, and many dryers then cut out on their thermal safety switch. Cleaning it takes a few minutes.
Clean a hair dryer filter
- Unplug and cool Unplug the dryer and wait until it is cool to the touch.
- Find the filter Look at the air intake at the back or the base of the handle. Many filters twist or pull off; the manual shows how.
- Remove the lint Pull off loose hair and lint by hand, then use a dry soft brush, such as an old toothbrush, on the mesh.
- Wash only if allowed If the manual says the filter cap can be washed, rinse it under the tap and let it dry fully, ideally overnight.
- Check the intake With the cap off, remove any lint you can see without poking inside the dryer.
- Refit and check Put the dry filter back, plug in away from water, and run it on low for a moment.
Clean flat iron and curling iron plates
- Cool completely Unplug and wait. Plates can stay hot for a while after switching off.
- Wipe Wipe plates or the barrel with a soft cloth dampened with water. Wring the cloth so it does not drip.
- Stubborn residue If the manual allows, use a little rubbing alcohol on the cloth for product build-up. Avoid abrasive pads that scratch coatings.
- Dry Wipe dry and let the tool air out before plugging it in again.
Clean a hot air brush or air styler
Pull hair out of the bristles with a comb or brush cleaning tool. Most air brushes also have an intake filter; clean it like a dryer filter. Many attachments come off, and the manual says which of them, if any, can be rinsed.
Clean hairbrushes and combs
- Pull out hair after each few uses.
- Wash plastic combs and brushes in warm water with a little shampoo, then rinse.
- Keep wooden handles and cushion brushes out of a long soak; wash the bristles and dry them face down.
Clippers and trimmers
Brush out cut hair after each use. Rinse the head only if the tool is marked as washable and is unplugged. Add a drop or two of blade oil as the manual shows, run it briefly, then wipe off the excess.
When to stop using a tool
Stop and replace or repair if
0 of 5 packedQuestions people ask
Why does my hair dryer smell like burning?
Lint or hair on the heating element or a blocked filter is a common cause. Unplug it, let it cool and clean the filter. If the smell continues, stop using it.
Can I vacuum the dryer filter?
Many people use a vacuum brush on the outside of the filter. Do not push anything into the dryer itself.
How do I test the safety plug?
With the dryer plugged in, press TEST; the plug should trip. Press RESET to restore power. If it will not trip or reset, stop using the dryer.
Can I use the dryer with the filter off?
No. The filter keeps hair and lint out of the fan and heater.
How often should I wash makeup brushes and hairbrushes?
Pull out hair often and wash regularly. FDA advises keeping cosmetic tools clean and not sharing them.
Sources
This guide is research-based: it draws on manuals, published specifications and safety guidance, not on hands-on testing. If we link to a retailer, we may earn a commission at no cost to you. Affiliate disclosure


